Bridging streams
#1
Bridging streams
I'm looking for ideas for bridging small streams. My property on which I hunt is inaccessable except by ATV. There is a small stream that runs thru the bottom center of it. I need to build some type of bridging and am limited by the challenge of getting materials in there. The stream normally runs avg 2-3 ft deep in dry season and leaves the banks in many places afte heavy rains. The site I have in mind has about 5ft banks and is 6ft from one side to another.
#2
RE: Bridging streams
http://www.extension.umn.edu/distrib...es/DD7005.html
go there maybe that will help you. You could use timbers on site if there are any available and haul a little bit of lumber in. I've seen many ATV bridges in remote areas they aren't too hard to build but they don't typically last all that long either.
go there maybe that will help you. You could use timbers on site if there are any available and haul a little bit of lumber in. I've seen many ATV bridges in remote areas they aren't too hard to build but they don't typically last all that long either.
#3
Giant Nontypical
Join Date: Dec 1969
Location: Townsend, DE US
Posts: 6,429
RE: Bridging streams
I use old creosote telephone poles , each about 10 ft long, level and cut treated 2x6 cut to 5 ft length and nail across the poles. You could also use landscape timbers and nail boards to them or use landscape timbers and get a couple old pallets and slide the timbers thru the openings and lay across the ditch.. I've done them all with success...
#5
Boone & Crockett
Join Date: Feb 2003
Location: Ponce de Leon Florida USA
Posts: 10,079
RE: Bridging streams
One that small I would use the power poles and deck it out. I would position it just downstream from a couple of trees and either chain or cable it to the trees so the high water doesn't wash it downstream.
#6
RE: Bridging streams
We have a spot like this.
We used 2ft diameter plastic culvert - and alot of field stones. On top we laid 2 Huge Steel Doors salvaged from a School renovation project. We can even drive the tractor across - but its a bit Narrow.
FH
We used 2ft diameter plastic culvert - and alot of field stones. On top we laid 2 Huge Steel Doors salvaged from a School renovation project. We can even drive the tractor across - but its a bit Narrow.
FH
#7
Nontypical Buck
Join Date: Feb 2003
Location: Ontario Canada
Posts: 2,059
RE: Bridging streams
#8
RE: Bridging streams
I would tend to shy away from culverts or any other structure like that if you want to retain full flood plain function etc. I would have to see what type of stream it is but I'm guessing a simple timber bridge would meet your needs just fine and probably be better hydrologically and biologically.
#10
Nontypical Buck
Join Date: Feb 2003
Location: Delhi, NY (by way of Chenango Forks)
Posts: 1,706
RE: Bridging streams
depends on the stream and site. easiest way is to drop a couple good sized logs (8"-10" or so) and pre-cut some 2x6 lumber and them make the bridge on-site. if you can get there with a atv, you can get the materials and tools in. this, however, is best on short spans (say <20' or so). we have one at our place and have a couple in the Adirondacks. one other thing to be mindfull of is high water. if it floods, your bridge will be downstream somewhere. we have one of ours anchored in the gound and to some trees.