walks with a gimp

640X480 maybe??

walks with a gimp

Cool, I don't have to re-size my pics anymore!! When did this change? I used to have to re-size then to about 1/2 the 640X480??

oscarg

thanks

Blodg

WWAG, from that pic it sure looks like the top center cable is crossing to the right of the lower cable?

walks with a gimp

Nope,, it's on the left side of the lower cable or "inside" the lower cable The slide is reversed with the drop away tab on top of the guard rod.

Blodg

Got ya WWAG, and I did put mine in a press today and switched my cables like yours and now I can use the MZE slide and cross the cables below the rod. Thanks everyone for the help.

alain

Russ, is this when the bow is at 'full draw'--?
The reason I asked, my bottom cam is perfectly straight while at rest. However when at full draw, the bottom cam pitches/leans to the riser.
And that's not difficult to see either!!!
I've also configured the cable guard with the longer slot towards the riser and my cables also crossing below the cable rod.
[/quote]
I dont know whats up with some allegiance, i have one and the cam lean is very,very minimal at full draw but its not my first one, a few weeks ago my dealer receive my first order(allegiance) but he returned it because the cam lean on both cam was not acceptable the bottom cam at full draw was like that / . the second one was much much better. My brother in law have a allegiance too and its like yours the top cam is straight but the bottom cam is leaning. I hope bowtech will find what is causing this?