Draw Length Adjustments on Pearson Bow
#2
RE: Draw Length Adjustments on Pearson Bow
It certainly is. They have modules to change it. Let me look at my spec sheet.
OK it calls for an M-8 module. If you look on the module yours should say M-10. If there aren't any nearby then you can use an M-8 from a Parker. They are identical.
OK?
OK it calls for an M-8 module. If you look on the module yours should say M-10. If there aren't any nearby then you can use an M-8 from a Parker. They are identical.
OK?
#3
RE: Draw Length Adjustments on Pearson Bow
just call up pearson and tell them what you need. For $15 you can get it directly from the factory shipped to your door and you can change it yourself. There are two allen head screws that hold the module on your cam remove them and the cam and replace with the new one, no bow press needed. You may need someone to draw the bow a little to get one screw in, I have to on my Anaconda but it is very simple.
Thread
Thread Starter
Forum
Replies
Last Post
Mathewsboy
Bowhunting
7
07-22-2004 09:02 AM