Bowtech limb bolts stripped.
#1
Fork Horn
Thread Starter
Join Date: Nov 2003
Posts: 138
Bowtech limb bolts stripped.
I just starting getting back into bowhunting so I purchased a used 03' Patriot SC all set-up. When I went to back down the wt. from 70lbs I noticed that the bottom bolt had rounded edges and confirmed this with the amount of play with the allen wrench. Is this an easy (inexpensive) fix for a dealer? I now have one bolt backed one full turn and the other @ 70. I also noticed that the top bolt turned very hard, at least harder than my old Martin, is this common? Thanks.
Tom
Tom
#2
RE: Bowtech limb bolts stripped.
I would think that if your dealer sold it to you that way he would fix it for you at no charge, if he did charge you he could have that bow apart and back to gether in a matter of minutes.I'm sure he would have limb bolt's available in stock .
nubo
nubo
#3
Join Date: Feb 2003
Location: Baltimore Maryland USA
Posts: 1,385
RE: Bowtech limb bolts stripped.
I had this problem and here's what I suggest. If, like me, your Dealer will fix it at his shop, BowTech will send the bolts at N/C. If you have to send it back, they'll take care of it immediately.
#4
Typical Buck
Join Date: Dec 2003
Location: Greenfield, IN
Posts: 953
RE: Bowtech limb bolts stripped.
Like was said above... limb bolts are easily replaced...
And the probable reason it's hard to turn is because the limb bolts need lubed.. mine was like that.. took it apart and greased it up.. now they turn alot easier.
And the probable reason it's hard to turn is because the limb bolts need lubed.. mine was like that.. took it apart and greased it up.. now they turn alot easier.
#7
Fork Horn
Thread Starter
Join Date: Nov 2003
Posts: 138
RE: Bowtech limb bolts stripped.
Thanks guys. I did not buy it from a dealer but I assumed that this would not be something to try myself. PABowhntr, where is the dealer in Lehigh Ct? I'm in Tannersville and was going to go up to Dupont but I'm a little closer to Allentown. Thanks.
#8
RE: Bowtech limb bolts stripped.
What would cause the harder steel bolt threads to wear and not the softer aluminum riser threads?