contact and question for ijimmy
01-15-2004, 12:51 AM
#1
Thread Starter
Join Date: Nov 2003
Location:
Posts: 27
contact and question for ijimmy
Subject: modified nap4000
ijimmy found you thread on modifing nap 4000 and want to try it.I have had the same problems!
When you ( drilled a hole in the bottom sideof the accuator bar so it could rotate 45 degrees) is the accuator bar the black square part that the braided cable goes through or the silver rod that the prongs attach to?
Thanks in advance for any help Jason
ijimmy found you thread on modifing nap 4000 and want to try it.I have had the same problems!
When you ( drilled a hole in the bottom sideof the accuator bar so it could rotate 45 degrees) is the accuator bar the black square part that the braided cable goes through or the silver rod that the prongs attach to?
Thanks in advance for any help Jason
01-15-2004, 05:52 AM
#2
Nontypical Buck
Join Date: Feb 2003
Location: WEST PALM FLORIDA
Posts: 2,890
RE: contact and question for ijimmy
As you can see in this picture , I drilled a hole in the bottem of the accuator bar and installed the same set screw thru it , its the set screw just next to the brass bushing . I should have said 90 degrees not 45 . Then used a small rope just like the trophy taker is setup . This worked great . With the stock setup of a cabel on the slide I was getting serious contact with my fletching .
