I NEED some Help!
02-02-2002, 05:14 PM
#1
Senior Member
Thread Starter
Join Date: Feb 2003
Location: WI USA
Posts: 110
I NEED some Help!
Well i ordered some new uni-bushings to put into my 2213s. Theyre the bushings that hold the G-series nocks. My problem is i cant get the uni-bushing into the shaft.Its just seems tooo tight. The bag they came in says 2213 so they are the right size. what should i do.
ryan
ryan
02-02-2002, 05:57 PM
#2
Nontypical Buck
Join Date: Feb 2003
Location: Vinton VA
Posts: 2,978
RE: I NEED some Help!
heat up the shaft a little with a torch, not to much, then put the bushing in as far as it will go, then push down on the arrow shaft while the bushing is on the floor( hard, not carpet). They are supposed to be snug to keep the bushing from turning. That should help some. You can also try a little soap on the bushing to help it slide in.
TAKE YOUR KIDS HUNTING AND YOU WON'T BE HUNTING FOR YOUR KIDS
TAKE YOUR KIDS HUNTING AND YOU WON'T BE HUNTING FOR YOUR KIDS
