HELP! Insert Problems
#1
Thread Starter
Join Date: Feb 2003
Location: Brownsburg Indiana
Posts: 48
HELP! Insert Problems
My field points will not go into an insert on one of my arrows. The point goes in about 1/8 inch and then it completely stops. No force could keep it moving. I think there might be dirt or sand stuck in there. I have carbon arrows with epoxied inserts. Is there a way I can replace the insert without damaging the arrow? Can I clean out the insert some way? Thanks for your help.
X-Ring
X-Ring
#3
Join Date: Feb 2003
Location:
Posts: 60
RE: HELP! Insert Problems
It' s probably the backwards way of doing it, but take one of your field points
and grind it down, carefully so you don' t mess up the threads, just enough so
it screws in all the way. Put some bow string wax on the threads so it doesn' t
loosen up.
and grind it down, carefully so you don' t mess up the threads, just enough so
it screws in all the way. Put some bow string wax on the threads so it doesn' t
loosen up.
#4
RE: HELP! Insert Problems
I keep a thread tap in my archery box so I can chase the threads when I have problems screwing in my field points or broadheads also it is a good idea to use antisieze compound on the threads this will prevent the therads from galding up.
Aluminum is especially bad about gading easily.
Aluminum is especially bad about gading easily.