bloodtrail1

What do you guys use to put in your uni-bushings with on carbon arrows? Super glue? or hot melt glue as you would with aluminum arrows?

bowjunkie

I use Goat tuff glue for all my carbon arrow components. It holds great and will break loose with heat to change things out.

Deleted User

[Deleted by Admins]

3DNWV

Ive tried just about every glue epoxy you can think of and goat tuff is the only one that has held up for me I use it for everything now

bloodtrail1

Where do you guys get the Goat Tuff glue?

bloodtrail1

ok....I went back to the shop where I bought my arrow shafts from, and just had them epoxy in the uni-bushings. They used a 5-minute epoxy, then right away stuck the uni-nock in the bushing. I questioned if by doing so, would the nock possibly glue itself to the bushing not allowing me to turn it! They said no, so this morning I tried to turn one of the nocks and I ended up turning the bushing! So...I removed the bushings, as the epoxy didnt hold very well! The 5-minute epoxy should have cured in 18 hours woouldnt you think? So..I one of the shafts I just tried some Bondini super glue which I use on inserts with great luck. After that sets up, I hope to be able to turn the nock! without the bushing turning!!