QAD tune up... *Update**
#12
RE: QAD tune up...
ORIGINAL: hmthtrfan
Using the LD
Using the LD
I've never had a QAD not get out of the way in time. Only issue was the bounce back as I mentioned with the hunter.
Only thing I can figure is that your nock point maybe too high/low or your center shot way in or out. Barring that, only a spine issue (and quite an issue it would be) or an improperly indexed arrow come to mind... unless something is broken.
#13
RE: QAD tune up...
all started after new string, other than that no changes on bow, I have tried high nock, low nock, even measured where I had it tyed in the first time, I am at a loss.
#14
RE: QAD tune up...
ORIGINAL: hmthtrfan
all started after new string, other than that no changes on bow, I have tried high nock, low nock, even measured where I had it tyed in the first time, I am at a loss.
all started after new string, other than that no changes on bow, I have tried high nock, low nock, even measured where I had it tyed in the first time, I am at a loss.
#17
Guest
Posts: n/a
RE: QAD tune up...
When you say fletch clearance, do you mean minor. Or are you saying the fork is not falling? You will be able to tell, because if it doesn't fall, you will usually get some fletch damage. And makes a horrible noise. How do you know its clearance?
#18
RE: QAD tune up...
it is minor clearance, the forks are droping, just not quite in time, get contact on the top 1/4" of the forks, shooting blasers, no contact at the top bar. i am using the ol' lipstick trick to see if I have clearance..
i have tried attaching it to the down cable at almost every 1/4" interval, still no change. it is coming full back in the last 1-1.5" of draw, I have nocked high, low, level, no change, i am really close to ebayin this thing and getting somethin different, I have never felt as defeated as this thing has made me feel.
i have tried attaching it to the down cable at almost every 1/4" interval, still no change. it is coming full back in the last 1-1.5" of draw, I have nocked high, low, level, no change, i am really close to ebayin this thing and getting somethin different, I have never felt as defeated as this thing has made me feel.
#19
Guest
Posts: n/a
RE: QAD tune up...
ORIGINAL: hmthtrfan
it is minor clearance, the forks are droping, just not quite in time, get contact on the top 1/4" of the forks, shooting blasers, no contact at the top bar. i am using the ol' lipstick trick to see if I have clearance..
i have tried attaching it to the down cable at almost every 1/4" interval, still no change. it is coming full back in the last 1-1.5" of draw, I have nocked high, low, level, no change, i am really close to ebayin this thing and getting somethin different, I have never felt as defeated as this thing has made me feel.
it is minor clearance, the forks are droping, just not quite in time, get contact on the top 1/4" of the forks, shooting blasers, no contact at the top bar. i am using the ol' lipstick trick to see if I have clearance..
i have tried attaching it to the down cable at almost every 1/4" interval, still no change. it is coming full back in the last 1-1.5" of draw, I have nocked high, low, level, no change, i am really close to ebayin this thing and getting somethin different, I have never felt as defeated as this thing has made me feel.
Another thing that could be happening is your nocking point for the arrow could be too low. Can you raise your D-loop a tad? Have you shot it thru paper?