redoakbuck

im shooting cx maxima 350's with 2 inh blazerson my 30" draw allegiance, limb driver rest. I'm shooting good groups bt my arrows are pretty noisy. Anybody know what causes it an what fixes it

brucelanthier

I would suspect a loose fletching. Blazers are quiet unless one end of the fletching becomes unattached to the shaft.

bowdaddy64

I have to agree, I shoot blazers too. Try putting a drop of super glue onfront and rear of vane right at ends to help hold them in place.

bucksnortinted

i don't think your fletching has anything to do with the noise,having a limbdriver on your bow the noise your getting is probally when your drawing your bow correct,stick a peice of mole skin on the fork arm of the rest that should take care of the noise...........Ted

redoakbuck

They arrows were bran new out of the boxcouple of the arrows did go through the target all the way. They seemed fine to me. I guess next time out Ill try with new arrows and see what happens. Iv'e also been told tha faster bows have noisier arrows is this true? This bow is new to me and mchfaster than my old bow

bucksnortinted

is the arrow noisy when drawing the bow or are you talking when the arrow is in flght.......Ted

redoakbuck

arrow in flight

bucksnortinted

i shoot an x force which is extremely fast and i can hear my arrows whizzin threw the air,check your fletchings and make sure they are not loose,on my blazers i put a dab of glue on the very end the same glue i put the fletchings on with carbon express,man you got top notch equipment if it is shooting accurate i wouldn't worry about it to much......Ted