ICS component ?
#1
Fork Horn
Thread Starter
Join Date: Feb 2003
Location: Liberty Indiana USA
Posts: 382
ICS component ?
If I wanted to install acc nock adapters and g nocks in my ics 340 hunter shafts, what size would I need to use? Will this be lighter than the standed 13 grain easton supernock and will it perform well on this shaft?
#2
Fork Horn
Thread Starter
Join Date: Feb 2003
Location: Liberty Indiana USA
Posts: 382
RE: ICS component ?
I forgot to ask what would be the best adhesive to install this bushing with? Do you have to do anything to the end of the shaft you are installing them in, or just glue them in and let dry? Thanks.
#4
RE: ICS component ?
I beleave its an A/C/C 3-60 componenet. Im not positive though. Cause ive been thinkin about doin the same thing. I would epoxy them in the shaft instead of hot glue, cause you can turn the nock. I dont know what im gunna use though.