Gold Tip Spine Advice
#1
Thread Starter
Join Date: Aug 2007
Posts: 2
![Default](https://www.huntingnet.com/forum/images/icons/icon1.gif)
My local bow shop cut me 6 arrows and told me he cut them to 26" - When measuring from very end of the field point to the very end of the nock they are a little over 27". Not including the field point and the nock they are under 26".
First question, what length arrow am I actually shooting?
Second Question is would you recommend the 3555 500's or the 5575 400's acording to my setup below
Gold Tip Spine Chart (http://www.huntersfriend.com/arrowhe...pine-chart.htm)
Drawlength - 27.5
Draweight - Between 61 - 62
100 grain points
P.S. It's a Guardian with 80% letoff - Thanks!![Big Grin](https://www.huntingnet.com/forum/images/smilies/biggrin.gif)
First question, what length arrow am I actually shooting?
Second Question is would you recommend the 3555 500's or the 5575 400's acording to my setup below
Gold Tip Spine Chart (http://www.huntersfriend.com/arrowhe...pine-chart.htm)
Drawlength - 27.5
Draweight - Between 61 - 62
100 grain points
P.S. It's a Guardian with 80% letoff - Thanks!
![Big Grin](https://www.huntingnet.com/forum/images/smilies/biggrin.gif)
#2
![Default](https://www.huntingnet.com/forum/images/icons/icon1.gif)
If I may I'll answer in reverse order.
5575 and no doubt about it.
Secondly, the correct way to measure arrows is: from the deepest part of the nock groove to the end of the cut shaft.
You do not include the length added by the insert although this is only about 1/8", nor do you include the point.
5575 and no doubt about it.
Secondly, the correct way to measure arrows is: from the deepest part of the nock groove to the end of the cut shaft.
You do not include the length added by the insert although this is only about 1/8", nor do you include the point.
Thread
Thread Starter
Forum
Replies
Last Post
MilDotMaster
Technical
7
01-13-2006 02:34 PM