DoninVa

I have been fletching arrows for at least 20 years and have always used fletch tite, but when carbon arrows came out,I've been less that satisfied with the glues avaliable for them until now. I used the new Bohning platinum fletch tite and what a joy. It works just like the old fletch tite for alums. I let each vane set for 10 minutes before removing the clamp. It leaves not white residue and doesn't run like the super glues even if you put a little to much on a vane. Don

Cougar Mag

I agree with you on the Fletchtite Platinum. I use it on Blazer vanes and feathers and am happy with the results.

BGfisher

Right on target. And it works especially well if the arrows are prepped properly to boot.

Swamp Dawg

Yep, I like it too. I got a wild hair and tried Goat tuff on the last batch. That stuff is a pain to remove. I will be going back to the Platinum Fletch Tite. Works great on carbon/quickspins.

98Redline

10 munites per vane?!!!

I let it sit for like 30 seconds. It is plenty set up by then.

supaarcher

Good to hear guys, All my vanes were falling off, so I bought some of this stuff and was going to redo my arrows one of these nights, glad I made the right choice