Problem with feathers...
#1
Problem with feathers...
I use an Arizona ez fletch to fletch my arrows and this past week tried to fletch some with feathers. About 1 in 3 have the same problem: the rear of the feather(nock side)must slide out while compressing the clamp, because it's curved at an angle (the feathers are RW, so they curve to the left, if looking from the rear). Anyway, they look bad. I think they do it because the barbs of the feathers are so short, they don't hold the feather stem in the clamp, and the natural curve of the feather pulls it out. How do I fix it? Thanks.
#2
Fork Horn
Join Date: Feb 2003
Location: Greensboro NC USA
Posts: 352
RE: Problem with feathers...
Maybe try something other than an EZ Fletch? I've used a regular fletching jig, and not had any trouble w/feathers.
My father-in-law uses an AZ EZ Fletch...but only on vanes.
Good luck!!!
My father-in-law uses an AZ EZ Fletch...but only on vanes.
Good luck!!!
#3
RE: Problem with feathers...
(the feathers are RW, so they curve to the left, if looking from the rear).
I have use it before with feathers and they went on just fine. Insert the feather a little foward int he clamp and slide rearward till it stops. Doing this will get the feather a little tighter in the slots.