Copper John?

Reply Subscribe

Thread Tools

07-13-2005, 05:44 PM

smitty1972

Thread Starter

Join Date: Jun 2004

Location: Pa

Posts: 63

Copper John?

was sighting new bow today and when I tried move pins they were VERY hard toslid up and down is this normal?

07-13-2005, 07:31 PM

Allseasonhunter7

Nontypical Buck

Join Date: Feb 2003

Location: auburn new york USA

Posts: 2,050

RE: Copper John?

yea but i think thats a good thind tap it with the allen wrench it should finly adjust it

07-16-2005, 06:45 PM

bigbuck270

Fork Horn

Join Date: Oct 2003

Location: Maine

Posts: 287

RE: Copper John?

loosen them up good and leave the allen wrench in to help slide them up and down.

07-17-2005, 05:43 PM

PABowhntr

Boone & Crockett

Join Date: Feb 2003

Location: Lehigh County PA USA

Posts: 12,157

RE: Copper John?

Your individual pins were hard to move or the entire sight bracket. I guess I am making some assumptions here. Which CJ sight are you using?

07-17-2005, 08:07 PM

extreme1

Nontypical Buck

Join Date: Feb 2003

Location: Ontario,Canada

Posts: 2,107

RE: Copper John?

I am shooting the Copper John Dead Nuts,and yes the pins are normally stiff to move up and down individually.Oviously very tight tolerances.
What bigbuck said works very well,just dont put alot of pressure on the end of the pin.
Best thing to do is site your 20 yard pin(or whatever range your 1st pin is set for)by moving the whole site ring itself.Then move the remaining pins individually.