IMR White Hots
09-15-2010, 05:06 PM
#1
Banned
Thread Starter
Join Date: Dec 2008
Location: Boncarbo,Colorado
Posts: 9,186
IMR White Hots
The last time i used them in the Hunterbolt i ended up having to beat the second shot down the bore due to the crud ring.
Now that its been UBC'ed i figured i'd give it another try.
100gr IMR White Hots, 245gr Powerbelt, Standard CCI Primers. First shot on clean bore was a bit high and the 2nd - 3rd shots were touching
Only 50 yards, I want to try 100 yards possibly tomorrow.
No crud ring at all, just felt a little bit stiffer to reload after the 1st shot but thats normal considering how much dirtier T7/IMR is.
This looks like a good shooting load out of the Hunterbolt, but once we get out to 100 yards, we'll see what happens.
I was also using the slotted breech plug *factory* so i am not counting this as an 100% success due to the amount of primer blow by thats allowed to escape into the bolt area.
I am not going to clean it tonight either, i want to see how the next shot is on a fouled but cold barrel.
Now that its been UBC'ed i figured i'd give it another try.
100gr IMR White Hots, 245gr Powerbelt, Standard CCI Primers. First shot on clean bore was a bit high and the 2nd - 3rd shots were touching
Only 50 yards, I want to try 100 yards possibly tomorrow.
No crud ring at all, just felt a little bit stiffer to reload after the 1st shot but thats normal considering how much dirtier T7/IMR is.
This looks like a good shooting load out of the Hunterbolt, but once we get out to 100 yards, we'll see what happens.
I was also using the slotted breech plug *factory* so i am not counting this as an 100% success due to the amount of primer blow by thats allowed to escape into the bolt area.
I am not going to clean it tonight either, i want to see how the next shot is on a fouled but cold barrel.
