I need 3 base mount screws
#4
Typical Buck
Thread Starter
Join Date: Jun 2006
Posts: 882
RE: I need 3 base mount screws
I had a old base off of a Remington action seem the rear 2 holes on the cva match perfect :I find the optima mag has a long rear stock and I have a 1.5x5 shotgun scope I would like to mount on it,I did cut the base and the front base mount sit far back so the scope can be pushed to the rear of the action.
I think 3 screws should hold up alright.I only have 2 screw mount on my thunderhawk and never did run into problems as far as the scope moving.
I had to use a 12MM socket on a 1/4 drive to remove the breech plug
I see no reason to send these plugs in snug is the way to go I also coated the treads with CVA breech plug grease and just finger tight
I check the bore to day man I think this gun don't have 30 rounds threw if that much
I think 3 screws should hold up alright.I only have 2 screw mount on my thunderhawk and never did run into problems as far as the scope moving.
I had to use a 12MM socket on a 1/4 drive to remove the breech plug
I see no reason to send these plugs in snug is the way to go I also coated the treads with CVA breech plug grease and just finger tight
I check the bore to day man I think this gun don't have 30 rounds threw if that much