The Dreaded Crud Ring
#1
Spike
Thread Starter
Join Date: Jan 2007
Posts: 22
The Dreaded Crud Ring
Took my new CVA OE to the range to try and work up a load for the upcoming blackpowder season and had crud ring issues. I was shooting triple 7 2F powder and the weapon would develop a crud ring after every shot so as to prevent another bullet from being properly seated. I was having to remove the breech plug between every shot and clean the barrel before I could reload. Also noticed that the breach would be covered with a grey grease like coating. I tried both pellets and loose powder with the same results. Was using Win 777 and kleanbore primers with little change. While cleaning some unfired powder would also fall out of the barrel. Has anybody else experinced anything like this. Would appreciate any help anyone could offer, I really need to get this problem resollved. Thanks.
#2
Nontypical Buck
Join Date: Feb 2003
Posts: 3,092
RE: The Dreaded Crud Ring
Sounds like you are getting gases back through the threads. I would try another breechplug but in the meantime (and maybe afterwards, try Sabotloader's method of taping the plug with teflon tape. A single damp (with water or Windex w/vinegar) patch, both sides followed by one or two dry patches should be enough to clear the worst of it.
You aren't leaving plug grease on the forward end of the plug, are you? Too much grease in the threads can push forward into the ignition area as the plug is tightenedand cause grief. There is no way you should need to fully clean after each shot.
You aren't leaving plug grease on the forward end of the plug, are you? Too much grease in the threads can push forward into the ignition area as the plug is tightenedand cause grief. There is no way you should need to fully clean after each shot.
#4
RE: The Dreaded Crud Ring
Underclocked is right on..
I have been giving the breech plugs of mine two wraps of white Teflon tape, then with a model builder's paint brush I paint a nice thin coat of anti seize onto the threads. I screw that in just finger tight. I still get a little blow back, but I live with it.
Swab the barrel between shots. Put a loading jag on the end of your range rod. Work a lightly damp patch in short strokes down the bore to the breech of the rifle. Then pull that and reverse the patch and do it all over again. Then a couple of dry patches and you should be set to fire. Do not worry about that gray stuff down by the breech plug,it will blow out with the next shot.
A good swabbing solution is Windex or car windshield washer fluid and alcohol mixed 50/50. There is no need to pull that plug until your done for the day.
I have been giving the breech plugs of mine two wraps of white Teflon tape, then with a model builder's paint brush I paint a nice thin coat of anti seize onto the threads. I screw that in just finger tight. I still get a little blow back, but I live with it.
Swab the barrel between shots. Put a loading jag on the end of your range rod. Work a lightly damp patch in short strokes down the bore to the breech of the rifle. Then pull that and reverse the patch and do it all over again. Then a couple of dry patches and you should be set to fire. Do not worry about that gray stuff down by the breech plug,it will blow out with the next shot.
A good swabbing solution is Windex or car windshield washer fluid and alcohol mixed 50/50. There is no need to pull that plug until your done for the day.
#8
RE: The Dreaded Crud Ring
ORIGINAL: roundball
Switch to real Goex blackpowder
Switch to real Goex blackpowder
With all the problems associated with T7 and the like, I'm amazed people don't just go back to real black powder.
Mike
#9
Join Date: Jul 2006
Location:
Posts: 5,180
RE: The Dreaded Crud Ring
why would he do that when he has a rifle that can shoot a sabot or conical with great accuracy, buy a centerfire barrel. Does a savage come in 45-70 caliber?
Now shadd up about this optima elite or else you will tempt me
Now shadd up about this optima elite or else you will tempt me
#10
RE: The Dreaded Crud Ring
What good is the CF barrel if he wants to hunt with ML? Or maybe even has too. Some states don't allow CF rifles at all. Better to get a great ML and a good CF rifle, than one mediocre switchbarrel. CVA's are cheap for a reason, and I for one wouldn't trust a CVA barrel with BP, let alone a high pressure CF rifle cartridge.
It's his money...
Mike
It's his money...
Mike